Decontamination and disinfection of dental impressions is vital to avoid not only patient/staff cross contamination during application, transport and processing but also to protect the surface quality of the impression itself.

UnoDent Impression Disinfectant is a concentrated disinfectant powder which is suitable for use on all kinds of impression materials such as silicones, alginates, polyether as well as for orthodontic impressions.

The unique composition is designed to clean and disinfect dental impressions without affecting the mould stability and shape.

UnoDent Impression Disinfectant Powder is easy to use and each tub includes a dosed, measuring scoop for simple dilution - 1 scoop per litre of water*

The highly effective disinfectant formula is fully Bactericidal, Yeasticidal and Virucidal against all enveloped Viruses in only 60 seconds.

Effective spectrum: Bactericidal: 60 sec

BS EN 13697:2015 BS EN 13727:2012 + A1:2013

• Pseudomonas aeruginosa: 60 sec
• Enterococcus hirae: 60 sec
• Staphylococcus aureus: 60 sec
• MRSA: 60 sec
• E-Coli: 60 sec

Yeasticidal: 60 sec BS EN 13697:2015 BS EN 13624:2013

• Candida albicans: 60 sec

Enveloped Viruses: 60 sec BS EN 14476 2013 + A1 2015

• Hepatitis B virus (HBV): 60 sec
• Hepatitis C virus (HCV): 60 sec
• Human Immunodeficiency Virus (HIV): 60 sec
• Human T Cell Leukemia Virus (HTLV): 60 sec
• Influenza Virus: 60 sec
• Hepatitis Delta virus (HDV): 60 sec
• Coronavirus: 60 sec
• Filoviridae (which includes Ebola virus): 60 sec
• Rubella Virus: 60 sec
• Measles Virus: 60 sec
• Herpesviridae: 60 sec
• Flavivirus: 60 sec
• Rabies Virus: 60 sec

Non-Enveloped Viruses: 60 sec BS EN 14476 2013 + A1 2015

• Adenovirus 5: 60 sec
• Murine Norovirus: 60 sec

Complete with measuring scoop.

20g makes 1L of 2% solution (700g makes 35L of working solution).

The following test standards have been achieved: EN 14885, EN 14476, EN 13727, EN 13697, EN 13624

Instructions For Use

Dissolve 1 level measure of powder (20g ± 2g) in 980ml of warm tap water (30 - 40°C) and mix for 60 seconds. Place the impressions into the solution and fully immerse for the 60 second contact time. Do not exceed this recommended time. Rinse immediately with copious amounts of running water. Change solution daily. For professional use only.